Search - Content
Search - People/Events
Search - Forums
Search - Finance/Stocks
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest

drawing on MW
(1 viewing) (1) Guest
Nonferrous topics such as copper and aluminum, annealing, etc. go here.
  • Page:
  • 1

TOPIC: drawing on MW

drawing on MW 2 years, 3 months ago #1443

hello guys
well i need to draw 7 wires on my NH MW machine with required size of 1.15 mm final
i only have a normal(not final die) of 1.15 mm so can i us it as final die & what will be the wire diameter?
thanks

ms

Re: drawing on MW 2 years, 3 months ago #1444

Hello again msaad10,

We are not clear of course on what your concept of a "normal" die or "final" or finish drawing die is. For instance, your "normal" die may be a standard carbide die or a polycrystalline diamond die whereas your "final" or finish die may be a solid industrial diamond or even perhaps, although unlikely, a standard carbide die.

For a short, special run, you should be able to use a carbide finish die instead of a diamond die but keep in mind that a polycrystalline finish die will create very small score (drag) marks along the longitudinal axis of the conductor. The final diameter of the conductor may be on size or perhaps very slightly smaller than the die size if a polycrystalline die is used.

You will have to experiment and hope that you will report your findings back to this Forum. Thank you.

Regards,
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
  • Page:
  • 1
Time to create page: 0.33 seconds