Moderators Note
This was inadvertently posted in another thread by new member xieuvanlieu .

"I make cable, and I need to calculate the equipment needed in a cable plant for project to manufacture 10.000T/Year. You can help me calculate the numbers machine (furnace, rod breakdown .. etc )"

Hello,

Judging from your location, there are two wire and cable machinery shows coming up shortly. We suggest you visit one or both of these fairs to discuss your requirements with drawing machine manufacturers.

Wire Southeast Asia
The International Wire and Cable Fair will be held on 16 - 18 October 2007 in Bankok, Thailand at the Bangkok International Trade & Exhibition Centre (BITEC) ( www.bitec.net/ )
www.wire-southeastasia.com/show_facts.html

Wire Asia 2007
The 12th International Conference and Exhibition for Wire, Cable, Fasteners, Springs and Other Products will take place from 7-9 November 2007 at the China World Trade Center, Beijing, P.R. China ( www.cwtc.com/ )
www.wireasia.com.cn/

The following companies manufacture continuous casting lines. We suggest you contact each of them to determine your most suitable course of action.

Continuus-Properzi S.p.A
www.properzi.com

Hazelett Strip-Casting Corporation
www.hazelett.com/

Southwire
www.southwire.com/processChannel.do?chan...CM1000002702a8c0RCRD

Upcast (Formerly Outokumpu) (They plan to be at Wire Southeast Asia)
www.upcast.com/tmp_basic_site_0.asp?lang=3&s=47&sua=1

Kindest regards,
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com

A little bit of thinking, using the internet (wirenet) etc. should make a lot of this easier.

Point being, you ask a question or tell about a problem and others respond or the vettcoupe gives you some suggestions.