Wirenet Image Band
wirenet.org mobile image band

WAI Forums

Joomla

× Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

Die Profile Checking

More
6 years 1 month ago #1181 by Archived Forum Admin
Archived Forum Admin created the topic: Die Profile Checking
We need to check die profile. Can anybody suggest an economical & quick method of checking dies after rework.
Regards

Please Log in to join the conversation.

More
6 years 1 month ago #1182 by Archived Forum Admin
Archived Forum Admin replied the topic: Re: Die Profile Checking
You have two simple ways of checking the profile
1.- one is to pull through the die a copper wire slightly bigger than the size of the die , one on the inlet and another on the outlet. the profile of the die at the entrance and at the exit will be shown on each one of the copper wires.
2.- Apply silicon to the hole of the die, wait till it sets , the pull it out. It will show the profile of the die

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.

Please Log in to join the conversation.

Time to create page: 0.264 seconds

Gallery

 

Contact us

The Wire Association Int.

71 Bradley Road, Suite 9

Madison, CT 06433-2662

P: (203) 453-2777