Wirenet Image Band
wirenet.org mobile image band

WAI Forums

Joomla

× Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

Wire break during drawing

More
6 years 1 month ago #936 by Archived Forum Admin
Archived Forum Admin created the topic: Wire break during drawing
Dear experts,
I found many times wire broken during drawing becasue of lube starvation.
We using pressure die and mechenical descaler and dry lube drawing.
Does anyone have some ideas on how can we improve to reduce lube starvation and then reduce wire break?
Thankd in advance.

Jincai Yang

Please Log in to join the conversation.

More
6 years 1 month ago #937 by Archived Forum Admin
Archived Forum Admin replied the topic: Re: Wire break during drawing
good day Jincai..

We use an Applicator on wire to stop dry lube tunneling, this applies pressure to wire and adheres the soap better, The company that makes these eludes me, but i'm sure someone has that info.

Please Log in to join the conversation.

More
6 years 1 month ago #938 by Archived Forum Admin
Archived Forum Admin replied the topic: Re: Wire break during drawing
Thanks very much. Would you please send me a picture for this?

Please Log in to join the conversation.

More
6 years 1 month ago #939 by Archived Forum Admin
Archived Forum Admin replied the topic: Re: Wire break during drawing
To avoid wire breakages, check:
1.- Wire Rod Quality(God Surface Quality,No Segregations,No Pipe).
2.- Adequate Die Profile
3.- Good calculation of the die series (adequate distribution of Reductions of area)
4.- Good lubrication(Good Carrier, Adequate type if lubricant.- sodium or calcium base).
5.- Adequate Drawing speed in relation of the above mentioned parameters.

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.

Please Log in to join the conversation.

More
6 years 1 month ago #940 by Archived Forum Admin
Archived Forum Admin replied the topic: Re: Wire break during drawing
morning YJC

the company name is Wire Lab Company
web site is www.wirelab.com
the site should give you all the info required on the applicators

Please Log in to join the conversation.

Time to create page: 0.299 seconds

Gallery

 

Contact us

The Wire Association Int.

71 Bradley Road, Suite 9

Madison, CT 06433-2662

P: (203) 453-2777