Wirenet Image Band
wirenet.org mobile image band

WAI Forums

Joomla

× Nonferrous topics such as copper and aluminum, annealing, etc. go here.

Brass wire drawing and online annealing

  • Archived Forum Admin
  • Archived Forum Admin's Avatar Topic Author
  • Offline
  • Platnium Boarder
  • Platnium Boarder
More
12 years 2 months ago #1531 by Archived Forum Admin
Brass wire drawing and online annealing was created by Archived Forum Admin
Hello,

I intend to cast brass in various grades at a diameter of 3/8" and finish to about 1/8". I would like to resistance anneal this wire and drop coil. Does any one have experience on this process? Most of the people draw copper only.

I would like to buy the required equipment for drawing and annealing this wire.

Please Log in to join the conversation.

  • Archived Forum Admin
  • Archived Forum Admin's Avatar Topic Author
  • Offline
  • Platnium Boarder
  • Platnium Boarder
More
12 years 2 months ago #1532 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Brass wire drawing and online annealing
Hello Kamkat,

Here is the information you are looking for:

Your SAMP contact for India

SAMP - Division Sampsistemi - Non ferrous
Via Calzoni, 2 - 40128 Bologna - Italy
Alessandro Spagnuolo
Tel. + 39 051 6319 411
Fax + 39 051 35 67 50

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Web: www.sampsistemi.com/


Your Niehoff contact for India

Niehoff of India Pvt. Ltd.
47/48 KM, Hyderabad-Mumbai National Highway
Hyderabad, India 502285
Tel: 91-8455-231-729
Fax: 91-8455-231-629

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Web: www.niehoff-gmbh.info/

Sincerely,
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com

Please Log in to join the conversation.

  • Archived Forum Admin
  • Archived Forum Admin's Avatar Topic Author
  • Offline
  • Platnium Boarder
  • Platnium Boarder
More
12 years 2 months ago #1533 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Brass wire drawing and online annealing
hanks for the reply vettecoupe, in the mean while some replies from people who have had some experience with the above subject could share the same , that would really help .

regards

kamal

Please Log in to join the conversation.

Moderators: Erik A MacsPeter J Stewart-Hay
Time to create page: 0.070 seconds

Gallery

Contact us

The Wire Association Int.

71 Bradley Road, Suite 9

Madison, CT 06443-2662

P: (203) 453-2777