Search - Content
Search - People/Events
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
All general discussions regarding the wire and cable industry should go here.

TOPIC: Cable sample preparation - antique version

Cable sample preparation - antique version 2 years 10 months ago #45

I was at the Roebling Museum in NJ today and they have various long length samples of antique bridge wire of relatively large diameter. The gentleman there (who used to work for Roebling years ago)seemed to believe that there used to be a machine which would hold the end of the cable and then cut and apply a wire band around the ends so it would not untwist and they could thus prepare short length samples. Does anyone out there have any idea about this type of machine or where one might be found? Even schematics or photos of something would be useful.


Erik Macs
VP North American Machinery Sales
The administrator has disabled public write access.

Re: Cable sample preparation - antique version 2 years 10 months ago #46

Eric,
I have seen sample of cable that were about a foot long and they had an aluminum band around each end. the Band looked to be a strip of aluminum, or a tube, that was about 1" wide and about 3/16" thick that had been slid over the cable and then clamped tight.
The administrator has disabled public write access.
Time to create page: 0.201 seconds