Search - People/Events
Search - Content
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

TOPIC: Wire Draw Dies

Wire Draw Dies 2 years 8 months ago #1016

We recently purchased a used Vaughn 5/6 Multi Head Wire Draw Machine.
The First drawing station is a double draw on a single shaft. The drive motor for this station is controled by a potentiometer and is based on the speed of the next draw head.
I understand the Die selection for this double draw station is very critical to prevent breaking the wire.
Question; What are the parameters to consider in calculating the die sizes for this double draw station.
The administrator has disabled public write access.

Re: Wire Draw Dies 2 years 8 months ago #1017

The parameters are de diameters of the same block (Top and Bottom ) and the die reduction of area

%die reduction =
100-100(Bottom Block Diameter/Top Block Diam)

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.
Time to create page: 0.283 seconds