Search - People/Events
Search - Content
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

TOPIC: Bending test for high carbon steel wire

Bending test for high carbon steel wire 2 years 8 months ago #1043

Dear All,

I have some problems on bending test of steel wire.when I checked torsion number, tensile strenght and wrapping test, everything is okey but on bending test # of bending is about 5-7. It should be more than 15. Please help me about how to increase # of bending without decreasing tensile strenght and etc.
and what is the reasons for low bending cycle.

Best regards.,
Murat

Murat
The administrator has disabled public write access.

Re: Bending test for high carbon steel wire 2 years 8 months ago #1044

Please give diameter and carbon content of wire to be tested.

In general, specifications call, as ductility indicator, for bend test or torsion test depending on the size of the wire, usually, do not call for both. Larger diameters are complicated to torsion test.

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.

Re: Bending test for high carbon steel wire 2 years 8 months ago #1045

carbon content 0,75
diameter 2,00-3,00 mm
best regards.

Murat
The administrator has disabled public write access.
Time to create page: 0.269 seconds