Search - Content
Search - Industry
Search - People/Events
Search - Forums
Search - Book of Terms
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinYoutubeFlickr
Welcome, Guest
Username: Password: Remember me
Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

TOPIC: Making compact rope

Making compact rope 4 years 4 months ago #1055

Dear All,

I produce compacted rope by usinf tungsten carbide dies for compacting of rope. However wire breakages occur during compacting due to friction. I have heard one system from EUROLLS (cassette system) is there anybody who use these kind of system for compacting.
I am looking for hearing you immediatelly,
Thanks for your help.
Best regards.
Murat

Murat
The administrator has disabled public write access.

Re: Making compact rope 4 years 4 months ago #1056

Guido Ricci
This email address is being protected from spambots. You need JavaScript enabled to view it.
Eurolls
Via Malignani # 14
33040 Attimis Udine- Italy
Tel 39 0432 796511
Fax 39 0432 786501
www.eurolls.com




Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.

Making compact rope 2 weeks 3 days ago #2957

Is there any difference between a compact wire rope and Swaged/hammered Wire Rope?

I am in the process of developing compact wire rope setup and need to find some literature to guide me in this process. I have few questions if anyone can direct me to the relevant sources to find their answers.

When do we use compact die vs rollers to compact the rope?
Is compacting done at all the stages of wire rope construction i.e core, strand and when the rope is finally closed?
Is there a criteria to prefer dies over rollers for compacting?
If we compact the strand how do we ensure that the flat size is outside when the rope is finally being closed?
In order to produced 14mm 6x19 construction compact rope, should the rope be designed for 15 mm and than reduced to 14 mm through compacting process? What is the allowable percentage reduction for compacting?

appreciate any input.

regards,
Faisal Mahmood
The administrator has disabled public write access.
Time to create page: 0.169 seconds