Search - Content
Search - People/Events
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

TOPIC: Die Profile Checking

Die Profile Checking 2 years 11 months ago #1181

We need to check die profile. Can anybody suggest an economical & quick method of checking dies after rework.
Regards
The administrator has disabled public write access.

Re: Die Profile Checking 2 years 11 months ago #1182

You have two simple ways of checking the profile
1.- one is to pull through the die a copper wire slightly bigger than the size of the die , one on the inlet and another on the outlet. the profile of the die at the entrance and at the exit will be shown on each one of the copper wires.
2.- Apply silicon to the hole of the die, wait till it sets , the pull it out. It will show the profile of the die

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.
Time to create page: 0.157 seconds