Search - Content
Search - People/Events
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

TOPIC: Lubricants

Lubricants 2 years 10 months ago #990

Hello,

I would like to know that first two passes are drawn with cal. base lub and other passes are drawn in sodim base lub.Pl. let me know the lub. percent in powder id imp.but what is the ideal percest in the powder. This is for my guide line so i can ask the suppliers accordigly.
jp
The administrator has disabled public write access.

Re: Lubricants 2 years 10 months ago #991

Look on www.wirenet.org technical, search abstracts for the following:

ID 6175.- Methods of testing and criteria for estimating the quality of technological lubricants used on wiredrawing by Monica Gierzynska

ID 6758.- Standardization of draw lubricants reduces error boosts productivity by Midlan States Steel and Wire

ID 2390.- Evaluation of Steel wiredrawing lubricants using radio isotope by Komuro

ID 2871.-Use of lubricants for corrosion protecction of hard drawn high carbon wire by Montajue

ID 1239.-What are the differences in wire drawing lubricants By Magnus Chemical

ID 4779.- An aid to the selection of wire drawing lubricants by Russell Smith

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.
Time to create page: 0.174 seconds