Search - People/Events
Search - Content
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Have a question on lubricants, wire drawing, quality, testing, ISO, environmental? Post your question here to get the answer!

TOPIC: Water removing device

Water removing device 1 year 9 months ago #2367

Please suggest me suitable device for water drop removing from running insulated wire at 200- 400 MPM in insulation line, wire diameter is from 1.2-6 MM.

mukesh
The administrator has disabled public write access.

Re: Water removing device 1 year 9 months ago #2368

An air wipe is the most commonly used item to remove water on insulated wire lines. In essence, air jets are pointed in the opposite direction of the wire. The clamshell style units use compressed air. The orifice size is matched close to the size of the final wire diameter to maximize efficiency of the wipe. There are also vacuum style units which are much more expensive but in certain cases can provide better wiping due to the warmer air generated by the regenerative blower. Compressed air style wipes can easily handle the line speeds you mention.

Manufacturers of air wipes include Huestis, Marldon and MGS. The addresses and contact info for these and others can be found in the Virtual Tradeshow section of this website.

www.wirenet.org/vts/vts_search.cfm

Erik Macs
VP North American Machinery Sales
Fine International Corporation
148 Oak Street
Natick, MA 01760 USA
508-315-8200 fax: 615-658-1988
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.
Time to create page: 0.300 seconds