Search - People/Events
Search - Content
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Have a question on lubricants, wire drawing, quality, testing, ISO, environmental? Post your question here to get the answer!

TOPIC: Inductive sensors

Inductive sensors 1 year 9 months ago #2445

Hi everybody,

I´m looking for an inductive sensor to control the quantity of wire in capstans in a wire drawing machine, the ones I´m using don´t run in an efficient way, manly by the distance between the capstan and the frame of the machine


Kindest regards
The administrator has disabled public write access.

Re: Inductive sensors 1 year 9 months ago #2446

Hello pedroardila,

I presume this is a zero slip wire drawing machine for steel wire which has vertical capstans and the turns of steel wire build up vertically on each capstan. If my understanding is correct, please advise and I will move this thread over to the Ferrous Section for a period of time as I think we will have more success in getting a response there.

Regards
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
519 641- 3212
The administrator has disabled public write access.

Re: Inductive sensors 1 year 9 months ago #2447

Yes sir, I´m tring to keep the machine running with a certain quantity of wire on the capstan.
thanks,

Kindest regards
The administrator has disabled public write access.

Re: Inductive sensors 1 year 9 months ago #2448

Hello again,

I looked under inductive sensors in Google and found 292,000 entries.

It looks like you are going to have to design your own system with the sensors of your choice.

Make sure when you mount them that the wire cannot tangle around them or get behind them and rip them out of the machine.

Good luck.

Regards
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
519 641- 3212
The administrator has disabled public write access.
Time to create page: 0.287 seconds