Search - People/Events
Search - Content
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Have a question on lubricants, wire drawing, quality, testing, ISO, environmental? Post your question here to get the answer!

TOPIC: Flexible Conductor Jointing

Flexible Conductor Jointing 1 year 3 months ago #2581

For the flexible conductor Class-5 or Class-6, what is the best method of jointing. Joint is not for electrical conductivity rather for continuous processing during extrusion. Is it welding or crimp or tying ?? please suggest the best method. :)
The administrator has disabled public write access.

Re: Flexible Conductor Jointing 1 year 3 months ago #2584

Hello,

From my perspective, I think welding, with a ceramic guide tube, is by far the best method for making a temporary splice at insulating. The splice of course has to be cut out after insulating regardless of which temporary splicing method is used.

The reason for my selection is the small clearance in the bore of the extruder tip (nipple).

If you tie or crimp, you have to remove some of the strands to make sure the splice can get through the the tip. This means that one needs to solder the overall strand at some short distance away from the end. Then one must carefully cut away some of the strands so those cut ends do not jam in the tip. It also takes time that you may not have.
Regards,
Peter J. Stewart-Hay Principal
Stewart-Hay Associates
www.Stewart-Hay.com
This email address is being protected from spambots. You need JavaScript enabled to view it.
Last Edit: 1 year 3 months ago by Peter J Stewart-Hay.
The administrator has disabled public write access.

Re: Flexible Conductor Jointing 1 year 3 months ago #2585

Thank you very much.. :) the method you recommended should be good for smaller cross-section conductors (upto 16sqmm?). I doubt whether it will work for bigger conductors aswell? May be a welding machine supplier can suggest.
The administrator has disabled public write access.

Re: Flexible Conductor Jointing 1 year 3 months ago #2586

Hello again,

This procedure works for large conductors as well and is used by many wire and cable companies with large CV lines.

A place to start would be AUGUST STRECKER GmbH & Co. KG www.strecker-limburg.de/de/ I suggest you contact them by fax or phone because they don't seem to respond quickly to E-mails.
Regards,
Peter J. Stewart-Hay Principal
Stewart-Hay Associates
www.Stewart-Hay.com
This email address is being protected from spambots. You need JavaScript enabled to view it.
Last Edit: 1 year 3 months ago by Peter J Stewart-Hay.
The administrator has disabled public write access.
Time to create page: 0.285 seconds