Search - Content
Search - People/Events
Search - Industry
Search - Forums
Search - Newsfeeds



jobcenterbanner

FacebookLinkedinPinterestYoutube
Welcome, Guest
Username: Password: Remember me
Have a question on lubricants, wire drawing, quality, testing, ISO, environmental? Post your question here to get the answer!

TOPIC: alloy equipment

alloy equipment 7 months 1 week ago #2768

Hello Dear Forum,

We're planning to run alloy core for 26 gage down in Mexico, I coming to this forum knowledge to ask for some suggestions to run it, I will receive the 2mm core just to pass it to the multiwire, then bunching, in your experience what will be the equipment to run it on the better way?? the strand OD is .16 average ( 7 strands ) and total OD .047 the alloy is Cu-Mg, please give me advices to buy equipment ....need a multiwire and buncher ( thinking in a 14 strands multiwire and two double twist buncher,
thanks in advance to everybody


regards,
The administrator has disabled public write access.

Re: alloy equipment 7 months 4 days ago #2775

Hello Martin,

We note that 2014 Fisk Alloy, Inc. manufactures this product in the USA. See www.fiskalloy.com/product/c18661/ for information on C18661 Copper-Magnesium (CMG1) Alloy Wire. Because this alloy can be manufactured by Fisk in three different tempers, {Half-Hard (H02) Hard (H04) and Spring (H08)} and because it is a high strength alloy, we recommend you discuss this alloy in detail with your machinery suppliers. (Select a number of them so you get the best possible information.) Our concerns include tensile strength and spring back. It is possible you may need a planetary machine like a tubular strander plus perhaps up to three closing dies in a row to lock the strand before releasing conductor tension after the pull-out capstan.

This is essentially all the information we have. Please be very cautious with your machinery selection.
Regards,
Peter J. Stewart-Hay Principal
Stewart-Hay Associates
www.Stewart-Hay.com
This email address is being protected from spambots. You need JavaScript enabled to view it.
Last Edit: 7 months 4 days ago by Peter J Stewart-Hay.
The administrator has disabled public write access.

Re: alloy equipment 7 months 11 hours ago #2777

Hello,

Thank you very much for the information Peter, as always very helpful information


Regards,
The administrator has disabled public write access.
Time to create page: 0.182 seconds