Wirenet Image Band
wirenet.org mobile image band
× Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

Drawing Die Angles

More
6 years 9 months ago #2638 by Jeff Christensen
In what situations does it make sense to increase (or decrease) the drawing angle?

Please Log in to join the conversation.

More
6 years 8 months ago #2639 by Eduardo Anaya
The drawing angle is affected by

1.-The reduction of area the die is performing ,

2.-The coating of the wire, if it is bright , galvanized or copper coated

3.-Drawing Speeds

4.-Type of lubricant use
The following user(s) said Thank You: vinay Bansal

Please Log in to join the conversation.

More
5 years 3 months ago #2835 by Peter M Power
In addition to the previous reply, it is very important to utilize the delta parameter calculation to guide the selection of die angle to fit the reduction in order to avoid the problems associated with a poor delta.

Please Log in to join the conversation.

More
2 months 3 days ago #3090 by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles

Jeff Christensen wrote: In what situations does it make sense to increase (or decrease) the drawing angle?

What shoul be angel of a bar drawing die

Please Log in to join the conversation.

More
2 months 3 days ago #3091 by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What is delta in die

Please Log in to join the conversation.

More
2 months 3 days ago #3092 by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What is delta in drawing die

Please Log in to join the conversation.

Time to create page: 0.189 seconds

Gallery

 

Contact us

The Wire Association Int.

71 Bradley Road, Suite 9

Madison, CT 06433-2662

P: (203) 453-2777