Wirenet Image Band
wirenet.org mobile image band

WAI Forums

Joomla

× All general discussions regarding the wire and cable industry should go here.

Cable sample preparation - antique version

More
6 years 4 months ago - 6 years 2 months ago #8 by Archived Forum Admin
I was at the Roebling Museum in NJ today and they have various long length samples of antique bridge wire of relatively large diameter. The gentleman there (who used to work for Roebling years ago)seemed to believe that there used to be a machine which would hold the end of the cable and then cut and apply a wire band around the ends so it would not untwist and they could thus prepare short length samples. Does anyone out there have any idea about this type of machine or where one might be found? Even schematics or photos of something would be useful.


Erik Macs
VP North American Machinery Sales
Fine International Corporation
148 Oak Street
Natick, MA 01760 USA
508-315-8200 fax: 615-658-1988
This email address is being protected from spambots. You need JavaScript enabled to view it.

This message was edited by vettecoupe on 3-3-11 @ 6:06 AM
Last edit: 6 years 2 months ago by Archived Forum Admin.

Please Log in to join the conversation.

More
6 years 4 months ago #9 by Archived Forum Admin
Eric,
I have seen sample of cable that were about a foot long and they had an aluminum band around each end. the Band looked to be a strip of aluminum, or a tube, that was about 1" wide and about 3/16" thick that had been slid over the cable and then clamped tight.

This message was edited by vettecoupe on 7-21-11 @ 6:49 AM

Please Log in to join the conversation.

Time to create page: 0.295 seconds

Gallery

 

Contact us

The Wire Association Int.

71 Bradley Road, Suite 9

Madison, CT 06433-2662

P: (203) 453-2777