Wirenet Image Band
wirenet.org mobile image band

WAI Forums

Joomla

× Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.

Lower Limit For Micro-rolling

More
6 years 5 months ago #862 by Archived Forum Admin
We are carrying out a feasibility study to replace tungsten carbide wire drawing dies with micro-cassettes in one of our wire drawing machines. Our target is to produce 0.84 mm low carbon wire with micro-rolls, keeping the ovality tolerance within +/- 0.01 mm. However, we are not quite sure, if we can obtain such a small size with micro-rolls without any problems.

Is there a lowest possible limit for the wire size that can be obtained with micro-cassettes on which most of the industry professionals agree? If yes, what is this value and would it be possible to obtain this size within +/- 0.01 mm ovality?

Please Log in to join the conversation.

More
6 years 5 months ago #863 by Archived Forum Admin
In principle cassett rolling is used to draw bigger diameters , big quantities with mayor tolerances.

This could be confirmed with companies on the field like Eurolls and Frigerio

Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.

Please Log in to join the conversation.

Time to create page: 0.301 seconds

Gallery

 

Contact us

The Wire Association Int.

71 Bradley Road, Suite 9

Madison, CT 06433-2662

P: (203) 453-2777